Catalog › Installation Guide: O2 Bung Relocation Installation Guide: O2 Bung Relocation

Instructions

1. Take the front pipe right off the car.

2. Draw a line directly backwards from the center of the O2 bung. This line is a guide that you will measure on.

3. Measure back along this line exactly 2 inches from the center (middle of the O2 hole) of the stock O2 bung. Mark the 2 inch point.

4. With a flexible measuring tape, measure 1.25 or 1¼ inches down towards the passenger side of the pipe.

5. This is the center of the new O2 bung. Drill your hole and weld it in here.

6. Plug the front O2 hole with the provided plug.

7. Use the extender on the new rear O2 bung.

8. Install the front pipe and then thread the O2 sensor into the extender.

9. You’re done…. Enjoy Going Solo!